Weaver GP38 Conversion May 30, 2016 11:37
Over on the O Gauge Railroad Forums, Max from Australia has documented a successful conversion of a poorly running Weaver GP38 locomotive to a smooth runner using one of our drive kits.
Quote from Max...
" All I did was add your adjustable tower to the P&D ball bearing motor and running gear (and trim the shaft).
The slow speed (notch 1) running is superb. "
I love to hear and see results like this!
Flywheel added to the Red Caboose GP9 September 27, 2015 13:54
A little extra space was need between the drive shafts to add a flywheel. Instead of hunting down shorter shafts it is easy enough to remove the spacer between the drive shaft halves. The half's are then reconnected with a 1/8" x .3" section of steel shaft. Enough space was gained to fit in a 1.2" x .75" flywheel made from mild steel.
Tower Kit Test Drive September 12, 2015 18:43
I have completed the assembly and test drive of the new tower kit. The 28 tooth lower gear was a little large resulting in the chain rubbing the frame sides on sharp curves. The 20 tooth gear is a much better fit all around with more chain clearance at the frame sides. Low speed performance is much improved over the stock gear and tower setup.
O Scale Adjustable Drive Tower September 05, 2015 10:20
O Scale adjustable drive tower replacement is currently being tested on the Red Caboose GP9 Locomotive. This bolt on replacement tower will replace the Weaver drive towers that utilize a chain drive.
Trex 550 Helicoptor Frame July 07, 2015 15:16
Take your Trex 550 to the next level!
Machined from 6061 aluminum alloy for incredible rigidity this frame will blow you away... hold on for a crisp, responsive flight experience like you haven't felt before.