Weaver GP38 Conversion May 30, 2016 11:37
Over on the O Gauge Railroad Forums, Max from Australia has documented a successful conversion of a poorly running Weaver GP38 locomotive to a smooth runner using one of our drive kits.
Quote from Max...
" All I did was add your adjustable tower to the P&D ball bearing motor and running gear (and trim the shaft).
The slow speed (notch 1) running is superb. "
I love to hear and see results like this!
Flywheel added to the Red Caboose GP9 September 27, 2015 13:54
A little extra space was need between the drive shafts to add a flywheel. Instead of hunting down shorter shafts it is easy enough to remove the spacer between the drive shaft halves. The half's are then reconnected with a 1/8" x .3" section of steel shaft. Enough space was gained to fit in a 1.2" x .75" flywheel made from mild steel.