News

Flywheel added to the Red Caboose GP9 September 27, 2015 13:54

A little extra space was need between the drive shafts to add a flywheel. Instead of hunting down shorter shafts it is easy enough to remove the spacer between the drive shaft halves. The half's are then reconnected with a 1/8" x .3" section of steel shaft. Enough space was gained to fit in a 1.2" x .75" flywheel made from mild steel.


Tower Kit Test Drive September 12, 2015 18:43

I have completed the assembly and test drive of the new tower kit. The 28 tooth lower gear was a little large resulting in the chain rubbing the frame sides on sharp curves. The 20 tooth gear is a much better fit all around with more chain clearance at the frame sides. Low speed performance is much improved over the stock gear and tower setup.

Read more here...